Can anyone tell me what service code 230-04 is and how to repair it for a Savin c4535 printer?
-
-
Don't normally see that error but this is from the book....
SC 230
230-004: K
Definition
The BCU generates the
FGATE signal based on the
registration sensor ON timing.
Then it sends the signal to the
LD units. The LD units send a
feedback signal to the BCU.
When the LD units start
emitting laser beams, the
feedback signal changes from
High to Low.
The SC code generates when
the BCU receives no feedback
signal (stays High) from the LD
unit 1 second after paper
reaches the position where the
laser should start writing.
Possible CauseTroubleshooting Procedure
1. Turn the main switch off and on.
2. Check the cables between the LD
units and the BCU.
3. Replace the laser optics-housing unit.
4. Replace the BCU.
Comment