mpc3300 fax

[CANCOUNTRY TECH]

hi all,

To use two lines with on fax do you just change ncu parameters 9&10 is there anything else that needs to be set?

Cheers

[Jomama46]

You need the 2nd G3 unit, goofy

[Eric1968]

Two fax lines on 1 fax unit! That would be something!

[Llama God]

You need the 2nd G3 unit, goofy

Ha!!!

[CANCOUNTRY TECH]

obvously its got the second g3 unit i didint think i had to be that specific i thought that would be understood when i asked the question

[TonerMunkeh]

Copied from the fax service manual:

1. Remove one of SG3 boards from the SG3 interface units and then attach the SG3 board to the other
SG3 interface unit ( x 2).
2. Remove the controller box.
3. Attach one end (short length) of the flat cable [A] to the connector [B] of the FCU board.
4. Hold the flat cable with two clamps and pass the other end of the flat cable through the cutout as shown above.
5. Remove the "LINE2" cover and "LINE3" cover with a screwdriver.
6. Connect the SG3 interface unit [A] to the controller board [B]

[teebee1234]

Just a little good natured ribbing. From your OP, it appears like your were saying 2 lines with on(e) fax.

[CANCOUNTRY TECH]

cheers toner munkeh both lines up and running.