I have gone in and raised the volume settings but there is no
Any ideas?
Thanks
Any ideas?
Thanks
-
-
It appears like you've already done the following.....
--------------------------------------------------------------
A Press the {User Tools/Counter} key.
B Press [Facsimile Features].
C Make sure the [Gen. Settings/ Adjust]
screen is displayed.
D Press [Adjust Sound Volume].
E Press [Lower] or [Louder] for each
item, and then press [OK].
*Here the display will show the volume sliders for each setting-
❖ On Hook Mode
Heard when the {On Hook Dial} key
is pressed.
❖ At Transmission
Heard when the machine sends a
document.
❖ At Reception
Heard when the machine receives
a document.
❖ At Dialing
Heard after pressing the {Start}
key, until the line connects to the
destination.
❖ At Printing
Heard when a received document
is printed. See p.97 “Print Completion
Beep”, Facsimile Reference <Advanced
Features> .
Note
❒ You can hear the actual volume
by pressing [Check].
❒ If you press [Cancel], the volume
setting is canceled. The display
returns to that of step D.
F Press the {User Tools/Counter} key.
The standby display appears.
----------------------------------------------------------------
These are the RAM addresses for volume, but I believe the values would change as you adjusted them through user tools.....
680492(H) - Transmission monitor volume 00 - 07(H)
680493(H) - Reception monitor volume 00 - 07(H)
680494(H) - On-hook monitor volume 00 - 07(H)
680495(H) - Dialing monitor volume 00 - 07(H)
680496(H) - Buzzer volume 00 - 07(H)
680497(H) - Beeper volume 00 - 07(H) -
user manual...Comment
Comment