mpc2500 dog earring

[pattyboy7]

Re: mpc2500 dog earring

There is the duplex lever that is connected to the right door. When the door is closed it sits just above the fusing unit and gets hot and brittle and breaks and also can get toner caked on it. Replace this if any of the pawls are broken or are spinning on the shaft.

Turn SP1950xxx (all of them under 1950) to anything greater than 30. This SP tells the fans how long to run and will cool the machine. The machine will be noisier after a print so make sure you think of that for how long you want the fans to run.

[Mark Bbb]

Re: mpc2500 dog earring

I notice that even with single face copies all the corners are bended, especially the front corners.. The paper has been in the tray for a few days now, so it might be that it is moistured.
Eureka! Problem solved:
the paper is colliding against the harness wich is located above the solenoide in the exit unit.
So, remove the bleu exit cover (located at the right of the receiving tray, that is actually the passage to the reverse tray for duplex) and pull the harness towards you, and make shure it never goes in the paper path again...