Ricoh colour 5560 heat roller damage!!!

[lary leon14]

I have a completely damage in the heat roller and the belt over it for the second time at 15k-20k copies!!!
Any advice???
Is there any modification or bulletin that keep healthy the heat roller for a long period?

[Paranoid]

Only thing I could find relating to Fuser roller damage was this bulletin. ThoughI remember from the Venus C-2 Course they mentioned the C-1 fuser did tend to get damaged easily, but nothing more was spoken about this.

[lary leon14]

Thank you!
I will try these setting's!!!
Thank's again!

[techsass]

Good luck. My Hot rollers always seemed to seperate after around 6 to 8 months, especially on the lower volume accounts.

[bat]

There are a few modifications regarding fuser belt and fusing rollers, but the key thing for increasing work life of fusing PM parts is fliping the upper or hot roller termistor, after some time, protective plastics on termistor becomes worn out and then metal contact can slice fusing belt like a razor, so I turned the termistor for a 90 degres and mounted it on fuser upper stay.