A PCC dongle was attached on a MPC 2800 usb port and it is working fine but there is a message on the screen saying the usb device is not compatible. Any SP to enable for this message to disappear. Thanks for your help.
-
Nobody is perfect.. -
SP5844-100 should do the trick -
ok i'll check that,thnxNobody is perfect..Comment
-
I have been told me that it is a bug with this last version of PCC.
It also hapened to me and i couldt solve it. See if that SP solves the problem. If it does say samething okLast edited by ricoco; 03-08-2011, 09:56 PM.Comment
-
PCC dongle? You mean a card reader?' "But the salesman said . . ." The salesman's an asshole!'
Mascan42
'You will always find some Eskimo ready to instruct the Congolese on how to cope with heat waves.'
Ibid
I'm just an ex-tech lurking around and spreading disinformation!Comment
-
yes it was a card reader with equitrac. I tried SP5844-001 but the message is still there.Nobody is perfect..Comment
-
' "But the salesman said . . ." The salesman's an asshole!'
Mascan42
'You will always find some Eskimo ready to instruct the Congolese on how to cope with heat waves.'
Ibid
I'm just an ex-tech lurking around and spreading disinformation!Comment
-
yes there was only two usb ports in the mahine, we tried to test the two ports but the message still appearsNobody is perfect..Comment
-
Re: PCC- print copy control
It's related to network firmware, it's fixed in the newest releases.
Its's 5844-100 (notify unsupported) set to "0" and a rebootrsyarciayes it was a card reader with equitrac. I tried SP5844-001 but the message is still there.Comment
Comment