Error Code SC740 on Ricoh Pro 907EX

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • atiq
    Technician
    • Jun 2010
    • 25
    #1

    [Error Code] Error Code SC740 on Ricoh Pro 907EX

    Hi,

    have a problem on a Pro 907EX coming up with a error code SC740.

    If you detach the finisher from the machine the error code goes away, but pluged back in the machine goes down.

    help would be gratefull.

    Thanks
    Atiq
    There are three types of people in this world: those who make things happen, those who watch things happen and those who wonder what happened.
    Tags: back, code, down, error, error code, exceeded, finisher, pluged, pro, ricoh
    • Ricohtechguy
      Technician
      • Apr 2011
      • 11
      #2
      Finisher Corner Stapler Motor Error Finishers B830/D434
      The stapler motor did not switch off within the prescribed time. The 1st
      detection failure issues a jam error, and the 2nd failure issues this SC
      code.
      SC740 D
      
      Number of sheets in the stack exceeded the limit for stapling

      
      If error occurred during stapling, stapler rotation sensor 1 defective
      (replace stapler)

      
      If error did not occur during stapling: staple jam:
      1. Motor blocked by an obstruction
      2. Stapler motor harness loose, broken, defective
      3. Corner stapler motor defective

      4. Finisher main board defective

      Check the staple cartridge and see if it comes out. If not then the motor is half way thru a cycle and the motor is jammed.

        Comment

        Previous template Next
        Working...