In Afi1224c, Fusing unit and oil supply units have been changed for picture print quality pbm. After replacing both, fuser oil is not getting added automaticallly. print quality is good now and i've added oil manually. without oil m/c doesn't give sc570 also.but in old unit, enough oil is there.when i tried 'add fuser oil' in sp mode, as soon as i press 'execute', display shows 'completed'. what can be the possibilities?
-
-
Sometimes you need to cycle the power before you can sucessfully force the oil supply from SP mode.
But if the sensor that detects the oil level was faulty or disconnected I would imagine you would be getting a SC error.
Have you visually checked the new oil supply unit since putting it in to see if it has enough oil in the tank? (should be roughly half full).- Knowledge not shared, is eventually knowledge that becomes lost... like tears in the rain.
Fully qualified technician for Ricoh - Canon - Sharp - HP - Brother - Knowledge not shared, is eventually knowledge that becomes lost... like tears in the rain.
-
check to see if one of the hoses came off in the back of the machine.Mystic Crystal RevelationsComment
-
have had this issue. check to make sure oil over flow sensor on fuser unit white connector with red wiring is not disconnected as if it is no oil will be added but the machine does not throw up an sc for some damn stupid reason
Comment
Comment