Sc534 error. I replaced the dulled fans left side and I can't get rid of this code. Am I missing a fan for this code or did I replace the wrong ones. Machine down. Ideas appreciated thanks. I got the part numbers by the way from the mpc7500 pl. Bulletin for this error? Thanks t
-
-
There is a Front Duplex fan motor (M29) and a Rear Duplex fan motor (M30). Page 834 S.Manual -
This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals | The Internet's largest selection of manuals | Instant Downloads
Paul@justmanuals.comComment
-
Polo I checked the fans in the rear and front of the duplex and the 534 still triggers. I ran all the fans in sp mode and they all fire up???????? What the f . I checked all the fans to see if i can catch one but all ok. Front and rear duplex fans ok too. Disconnected each one turned on/off and same deal 534. Hmmmmmmmm? Again what the f. Thanks tComment
-
PN : AX640158 (X2). Page 113 item 7. (Parts list from MPC 7500 S.M.).
Just under the two transport belts...Comment
-
polo i have both the fans on order. i tried looking for a cross in the boneyard because the machine is down. but can't find one. checked a few index lists for the machines in the warehouse but no luck. i'll have to wait until they come in. thanks tComment
-
Have you checked the small fan that sits above & the left of the duplex fans? Will give same code if not workingComment
-
semi i did check the one sitting above the left dup fan in sp ok. voltage is good and it fires up unfortunately i dont know if its suppposed to be hi at or low. it does start in hi along with the lower left but the right starts in low then goes hi and triggers the 534. these r the ones finisher side im talking about. got the fans in polo was talking about and i have my tech going out tomorrow. thanks tComment
-
Re: mpc 6501
We are having this same problem. Would you mind posting the cause/solution?
Thank you so very much for your time and assistance!Comment
Comment