CL7200 Banding on cyan and black prints

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • dstew67
    #1

    CL7200 Banding on cyan and black prints

    I recently replaced all of the changeable portions of my CL7200 (PCU, Toner, Developer) and after I did so, I started getting stripes in the cyan and black portions of my prints (see image below). These stripes are in the same position on every page I print and show up in the same places when you use a color that would be a mix of the cyan and black. Is there a way to clean the PCU or the Developer for those two colors or do I need to just bite the bullet and get new PCU and Developer units?

    Thanks,

    Daveimg005.jpg
    Tags: 200, black, color, cyan, developer, image, pcu, print, prints, toner
    • JustManuals
      Field Supervisor

      5,000+ Posts
      • Jan 2006
      • 9838
      #2
      Re: CL7200 Banding on cyan and black prints

      This Parts & Service manual can be purchased for $12.77 and downloaded immediately after payment from

      Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads

      Paul@justmanuals.com

        Comment

        • rthonpm
          Field Supervisor

          2,500+ Posts
          • Aug 2007
          • 2847
          #3
          Re: CL7200 Banding on cyan and black prints

          It's an issue with the developer clutch. It begins to slip and feeds out more developer than it needs to and before long you've got zebra pages thanks to a low developer volume. If you're an end user, this is an issue for a tech to resolve.

            Comment

            Previous template Next
            Working...