Hello, I have an MPC 3000 with a dead control panel and through the WIM i see a 202 code. I have disconnected the laser but to no avail. Any ideas out there?
-
-
Re: MPC 3000
This Parts & Service manual can be purchased for $12.77 and downloaded immediately after payment from
Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com -
Re: MPC 3000
SC 202 Polygon Motor error - check for pinched wire in laser unit harness behind fax option ( if installed ) SC 202 Polygon Motor error - replace BICU if CN520 has no trigger on pin 3 SC 202 Polygon Motor error - replace Polygon Mirror Motor Comment
-
Re: MPC 3000
bicu and polygon mirror motor fixed my issue as well. replaced as set.Comment
-
Re: MPC 3000
had this exact issue last week. dissconnecting the HDD brought the screen back on for me then connected it back up but still got sc202. ordered and went back with a polygon motor which fixed.
didnt have to fit the BICU, you might want to test this in another machine to check, its an expensive part to fit when not needed.....
cheersComment
Comment