About Supervisor

[hosennet]

How do input the supervisor mode for SSP
Any ideals

Best regards

Email:hosennet@gmail.com

[Cipher]

There is no supervisor mode for SSP as far as I know.

The only supervisor I can think of is on the newer controllers which is used to reset lost admin passwords.

[hosennet]

There is no supervisor mode for SSP as far as I know.

The only supervisor I can think of is on the newer controllers which is used to reset lost admin passwords.

[Cipher]

Thanks DaZ

Can you help me about next problem:

SC 999 or “Fusing Unit Setting Error” can be shown until the device number and destination code are correctly programmed.

Contact your supervisor for details on how to enter the device number and destination code



Regards

LOL done a memory all clear or a NVRAM replacement have we?

Ok just tell me the model and I'll drop you a PM.

[Tonerbomb]

LOL done a memory all clear or a NVRAM replacement have we?

Ok just tell me the model and I'll drop you a PM.

Nice!!!! nothin'like NVRAM to make your day!


Props to DAZ for being discrete!!!!!

[hosennet]

LOL done a memory all clear or a NVRAM replacement have we?

Ok just tell me the model and I'll drop you a PM.

Thanks DaZ

Model : MPC 2500

Regards

[Cipher]

LOL PM sent.

[hosennet]

LOL PM sent.

Sorry DaZ

What's LOL?

My mean is next:
1.Change the LCDC firmware for MPC 2500 (Asia version)
2.Change fusing unit one circuit for area version

Display "Fusing Unit Setting Error"
I don't know how to change DIP SW from BICU or control board
and must doing any thing for achieve job

Help me please!

[Cipher]

Laughing Out Loud @ tonerbums comment

PM = Private Message (sent to you).

[hosennet]

Laughing Out Loud @ tonerbums comment

PM = Private Message (sent to you).

I get it

Thank you very much

[jours]

Same problem (maybe)...

LOL done a memory all clear or a NVRAM replacement have we?

Ok just tell me the model and I'll drop you a PM.

Hey DaZ,

I'm having the same problem with a customer's AP3800C multi-function. SC999. I tried a hard drive on the suggestion of another tech but no dice. I'm not really a Ricoh guy but I would like to help him if I can. He's a bit of a tinkerer and even has a service manual for his unit so I'm afraid he may have fiddled with it. An "All clear" is a distinct possibility.

Can you give me an idea how to check if this is the case...and how to fix it if it is?

Thx.

[jours]

I'm afraid he may have fiddled with it. An "All clear" is a distinct possibility.

OK, I stopped out again this afternoon and the service menu shows no english text at all and SP5-808 is 0, so I'm pretty sure this is what happened. Trouble is I can't edit that value..?

[kgbeatty]

Need to Reprogram Destination Code

Can some help me reprogram the destination code on a ricoh AP 3800c?

[jours]

Can some help me reprogram the destination code on a ricoh AP 3800c?

It's been awhile but I think I solved this by pulling the MF expansion out, resetting it through the printer controls, and then reinstalling the MF board.

[kgbeatty]

I've been told I need to enter factory mode instead of Service Mode. Do you know how to do this?