Hi All,
I have an SR3000 in the workshop, and removed the staple tray, then removed the motor and gearing because the arm that held the black stopper that swings round to hold the sheets before stapling, was warped, and was causing the staple unit to stick halfway along.
The upshot of doing this, has meant that 2 large black gears with cams on them, are in the wrong position.
I have read the latest manual, and it does not give you any instructions on what position to set them at, just what they do.
Has anyone had a similar issue, and do you know how to align them correctly?
I've even checked the bulletins, and the knowledgebase to find a solution, but can't find anything.
Cheers
SB
I have an SR3000 in the workshop, and removed the staple tray, then removed the motor and gearing because the arm that held the black stopper that swings round to hold the sheets before stapling, was warped, and was causing the staple unit to stick halfway along.
The upshot of doing this, has meant that 2 large black gears with cams on them, are in the wrong position.
I have read the latest manual, and it does not give you any instructions on what position to set them at, just what they do.
Has anyone had a similar issue, and do you know how to align them correctly?
I've even checked the bulletins, and the knowledgebase to find a solution, but can't find anything.
Cheers
SB
Comment