Ricom MP2500

[GeorgeBest]

Strange skew problem on this machine.
First part of copy/print is good, but at the end the image is skewing !!
No matter from what drawer the paper is coming, even from multy tray.
Replaced the bushings from registration roller, no result.

Not much experience on this one.

Anyone . .?

Thanks in advance

[JustManuals]

Re: Ricom MP2500

This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from

Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com

[ricohmaina]

Re: Ricom MP2500

Does it do it on every paper size and direction? How many clicks?

[Jomama46]

Re: Ricom MP2500

I would have guessed spings on the reg roller, but I see you looked at that. How much of the end is skewed? One way to ts this is to put paper back into the copier so that the skew is on the transfer roll, then look at where the lead edge is, since that is pulling the copy thru. Also not where the trail edge is, is it just leaving a roller?

[ricohmaina]

Re: Ricom MP2500

If I was guessing. I'd say that either the front or rear, probably the rear tab that holds the transfer bushing in place is either broken or missing.