SC819-DSC445

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Butrus
    Trusted Tech

    100+ Posts
    • Jan 2012
    • 115
    #1

    SC819-DSC445

    Nashuatec DSc445 gives me code SC819
    also displays at the end of the SC the following
    7061 6765 6f75 743a 20

    Have the manual,but dont have RTBs
    10h and 5e should explain this...

    Replaced the two RAMs,but its the same...

    Thanx
    Tags: None
    • luke001
      Technician
      • Dec 2011
      • 46
      #2
      Re: SC819-DSC445

      SC819 (Fatal Kernel Error) appeared when the machine was turned on.
      Cycling the machine off/on temporarily restored operation but the error recurred. Remove and re-inserting the controller board had no effect.
      There were poor connections between the DIMM/SDRAM and the controller/motherboard or poor connection controller or bad HDD.

        Comment

        • Butrus
          Trusted Tech

          100+ Posts
          • Jan 2012
          • 115
          #3
          Re: SC819-DSC445

          Thanx for reply Luke,

          the RAM I put in was from spc410 which happens to be the same
          The SC remained....
          However,when I put in the original RAM,machine started working normally again...

          Is problem solved or can it happen again?
          What coused it?
          Bad connection?Hard to belive so,since I triple checked that before I put in different RAM...

          Thanx

            Comment

            • luke001
              Technician
              • Dec 2011
              • 46
              #4
              Re: SC819-DSC445

              Numbers indicate errors in the RAM. Could be corroded contacts on RAM or connector. Lately, there are defects Controllers.

                Comment

                Previous template Next
                Working...