Re: mp c3500 not adding toner black
Add Toner = Print off a Non default smc if you can. Drop the NVRAM full reset. Load in the non default settins and set up the registration. VERY INPORTANT to do the reg.
This will sort it.
Fault caused by the Chip in the toner bottle not given the correct MR reading to the BCU causing add toner. One way to see this is turning on toner icons in SP 5--- . Your see one of the colours missing.
This works every time for me.
Good luck
mp c3500 not adding toner black
Collapse
X
-
Re: mp c3500 not adding toner black
thanks everyone for your input, it's all taken into consideration as it is likely to happen again, and likely for different reasons.
But in this case it was the controller board - yes, controller board. We had a few machines doing weird things after thunderstorms in July and August - surge protectors are a must!Leave a comment:
-
-
Re: mp c3500 not adding toner black
You COULD try the NVRAM/Engine clear but it's mostly the fix for the MPC2500/2800/3000 range.
If the dev unit is well over life you may as well change that at the same time....as everyone has stated it's usually either a blocked pipe or a pump on the 3500/4500.Leave a comment:
-
Re: mp c3500 not adding toner black
It could be the toner bottle detect board at the back. I've had one or two of those go before after replacing the pump(s) to no avail.Leave a comment:
-
Leave a comment:
-
Re: mp c3500 not adding toner black
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.comLeave a comment:
-
Re: mp c3500 not adding toner black
Does it actually say Loading Toner when you remove and replace/refit the bottle?
If not it could possibly be theres a Cover OpenLeave a comment:
-
-
I've only ever changed one pump. Invariably I've always found the supply pipe is blocked.Leave a comment:
-
Re: mp c3500 not adding toner black
I agree the pump is always the problem, in my experience, with this problem. I've never seen anything else on these machines.Leave a comment:
-
Re: mp c3500 not adding toner black
Hi,
I can almost guarantee that this is the toner pump i must have fitted over 50 of these, if non oem toner is used then its 100% the problem. when you change it i would also give the nozzle a clean too.
RegardsLeave a comment:
Leave a comment: