MPC4500

[Blazer1087]

Hello everyone, This morning I am going to replace all the develeper units on a mpc4500. I havent done this before and was wondering if any thing needs to be done other than setting 3902-1-4 to 1 before I shut the copier down? Will the ACC adjustment automaticaly be done or should I do it when I am done? Thanks for any information. I did looked in the SM and it isnt clear on this.

[Eric1968]

Re: MPC4500

After you replace the development units, run color calibration and color registration in user tools. Make sure the optics are clean when you scan the prints.

[Blazer1087]

Re: MPC4500

Thats what I needed to know, thanks alot!