The control panel don't show. But appear SC672 have display. Have replaced the following board: GW panel, BCU, power panel, IPU board, VIB board, CNB plate, machine have action, exposure with the lights burning. Excuse me, is the machine lock. Ask everybody to help me.
-
-
Re: Ricoh AF1075 The control panel don't show. But appear SC672 have display.
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com
-
Re: Ricoh AF1075 The control panel don't show. But appear SC672 have display.
Try to clean the slide in contact point of the controller board, or the worst is replace the controller board.Comment
-
Re: Ricoh AF1075 The control panel don't show. But appear SC672 have display.
we have this kind of SC code with a DSM675 and it was the AZ23 0140 Power Supply Unit DOM/NA that's defective.Nobody is perfect..Comment
-
Re: Ricoh AF1075 The control panel don't show. But appear SC672 have display.
This may sound silly, but pull out BOTH sides of the tandem tray and switch on. I have had a 24 line to the solenoid on the front of the tray short to the rail and take down the backlight on the panel. Also check that you get all the 24v lines to the panel, you can remove the complete panel, including the frame, turn it over and check all the inputs. It could be the direct 24v line from the PSU.Comment
Comment