MPC 2500 Toner supply rate

[m_donakov]

Hi all

I have Ricoh MPC 2500 first i got light cyan copy, i forced toner in DV Unit and make TD sensor initalisation and copy is now ok but it ask for toner after several pages, and i must open and close the front door. So if you can tel me it is posible to increase toner supply rate for cyan. Or if it posible to turn back TD sensor voltage on the stage before because then cyan was lite but no other problems

Thanks

Regards
Mile

[Max]

Re: MPC 2500 Toner supply rate

It more likely that the pump is on its last legs/supply pipe blocked or the Dev is way way past its life (160k life give or take if i remember correctly) Don't mess with the voltages you will be by passing the real prblem.

[Bantams]

Re: MPC 2500 Toner supply rate

If you initialized the TD Sensor with a worn dev unit its going to keep asking for toner the only fix is to replace either the cyan dev or the dev unit assy depending on copy count if over 200k col id replace the Unit.

[m_donakov]

Re: MPC 2500 Toner supply rate

Thanks for sharing your opinion, i reset engine memory after that i make all adjustments(line adjustments) and now everything is ok, i make mistake before because i tuned off toner detection and leave DEV unit without toner after when i install new toner i get light cyan copies for that i make TD sensor initalisation.


thanks

Mile

[JustManuals]

Re: MPC 2500 Toner supply rate

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com

[TonerMunkeh]

Re: MPC 2500 Toner supply rate

Thanks for sharing your opinion, i reset engine memory after that i make all adjustments(line adjustments) and now everything is ok, i make mistake before because i tuned off toner detection and leave DEV unit without toner after when i install new toner i get light cyan copies for that i make TD sensor initalisation.


thanks

Mile

Woah, hang on. You did an engine clear AFTER you made the adjustments?

[SargeNZ]

Re: MPC 2500 Toner supply rate

i reset engine memory after that i make all adjustments(line adjustments) and now everything is ok,

Translated: I reset the engine memory. After that, I made all of the line adjustments (I guess he means force line pos. adjustment??) And now everything is O.K.

[Llama God]

Re: MPC 2500 Toner supply rate

Woah, hang on. You did an engine clear AFTER you made the adjustments?

Bloody drama queen...

[TonerMunkeh]

Re: MPC 2500 Toner supply rate

Bloody drama queen...

Beats being an angry ginger dwarf

[TonerMunkeh]

Re: MPC 2500 Toner supply rate

Translated: I reset the engine memory. After that, I made all of the line adjustments (I guess he means force line pos. adjustment??) And now everything is O.K.

Aaah, thank you very much for the translation

[m_donakov]

Re: MPC 2500 Toner supply rate

Aaah, thank you very much for the translation

Yes Force line adjustments Thanks

[Llama God]

Re: MPC 2500 Toner supply rate

Beats being an angry ginger dwarf

Shut it, southern puff.