[Error Code] error sc 120

[margic brian]

hello to everyone
this question might have been asked before but i please would like your help, just recently installed scan features on an mp2000 fully(scan to folder) but this the error i get sc120 what could be the problem your help will be highly appreciated
thanks in advance

[Eric1968]

Re: error sc 120

Scanner Home Positioning Error. Could be a defective Home Positioning Sensor.

[sandmanmac]

Re: error sc 120

hello to everyone
this question might have been asked before

May have been asked before? No kidding.
It's an SC code. You supposedly work on copiers for a living, and you don't even have the capacity to look up a simple SC code?
At least make an effort. Just try the search function. I did, and found several posts about it

[JustManuals]

Re: error sc 120

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com

[margic brian]

Re: error sc 120

May have been asked before? No kidding.
It's an SC code. You supposedly work on copiers for a living, and you don't even have the capacity to look up a simple SC code?
At least make an effort. Just try the search function. I did, and found several posts about it

i know you aint kidding but this sc code only appears when i use the scanning option so to me it appears rather tricky and i can only clear it when i switch the machine off and on. and besides its a new copier. thanks

[Llama God]

Re: error sc 120

Better speak to Paul...

[Herostrat]

Re: error sc 120

Paul speaks...like he can say something other than:
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from:


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com???

[ma3xx]

Re: error sc 120

Hi, Im new here. I got the same problem as u few days ago. The solution is belt on the lamp is too tight. Loosen it a bit. Remove the scanner glass and at the left most side you can see a screw, just below the ADF glass, on the loop of the belt. Loosen it both side and its solve.

[margic brian]

Re: error sc 120

Hi, Im new here. I got the same problem as u few days ago. The solution is belt on the lamp is too tight. Loosen it a bit. Remove the scanner glass and at the left most side you can see a screw, just below the ADF glass, on the loop of the belt. Loosen it both side and its solve.

hi man thanks for your advice i used white grease instead to help the scanner move freely other than your method but the fact that you showed me where to touch i highly appreciate