[Misc] How to reset drum counter & initialize developer on Savin 816

[spanky]

I replaced the drum/dev unit on the Savin 816, but it still say to replace the photoconductor.
How can I reset the drum counter and initialize the developer so I can use this drum/ dev unit in the machine.
I am not a Savin tech, I am a Sharp tech and as usual my boss thinks all copiers are the same.

Thank you in advance for any help I can get on this issue.

[skynetto]

Re: How to reset drum counter & initialize developer on Savin 816

http://www.copytechnet.com/forums/ri...rum-reset.html

Savin 816 = Ricoh MP161

Check the link above

[nmfaxman]

Re: How to reset drum counter & initialize developer on Savin 816

I would just turn off the indicator in service mode and let it run till I had to replace it.
Sp mode, code 5912 set to "1".

[Athlontini]

Re: How to reset drum counter & initialize developer on Savin 816

I would just turn off the indicator in service mode and let it run till I had to replace it.
Sp mode, code 5912 set to "1".

I never encountered this until I had a call for the Gestetner version of this model. Dunno if this is something we adjust during initial setup so that I never see it, or what.

But anyway, bottom line, SP7992-4 is what OP needs.

[spanky]

Re: How to reset drum counter & initialize developer on Savin 816

I never encountered this until I had a call for the Gestetner version of this model. Dunno if this is something we adjust during initial setup so that I never see it, or what.

But anyway, bottom line, SP7992-4 is what OP needs.

Thanks all, I with your help I found the information in the service manual.

I reset the counter and forced the toner initialization.

All works fine now.