Ghost image

[MWALA]

I have aficio 1015 with ghost imaging. I replaced the heat roller, heater lamp thermistor and pressure roller but the problem wont go. Its affecting the top side and the bottom side. What is the solution.

[Debs1964]

Re: Ghost image

Is it possible that someone has put the wrong toner in it

[MWALA]

Re: Ghost image

I tried another imaging unit but the same problem

[Bantams]

Re: Ghost image

Check the pressure roller bushes they tend to wearout unevenly and cause lack of pressure between the press roller and hot roller.

[khaled_abosere3@yahoo.com]

Re: Ghost image

Check the pressure roller bushes they tend to wearout unevenly and cause lack of pressure between the press roller and hot roller.

You right

[Herostrat]

Re: Ghost image

What's the density of toner in prints,can u feel it under your fingers,check if toner type is "for use",did you replaced hot roller with "for use" one?
Try enabling Fusing idling on SP mode,inspect thermistors and bearings,I change those on every hot roller change...with fingers ofc.
If you tryed another PCU in that machine it doesn't mean it will form better image,machine engine may still add more toner no matter what PCU is inside,because it remembers the settings for previous PCU.
Ensure that all assembly's are working proper before the one causing problems

[jonhiker]

Re: Ghost image

Check the pressure roller bushes they tend to wearout unevenly and cause lack of pressure between the press roller and hot roller.

i had the same issue and this was the cause. cheap fix.

[Polarbear]

Re: Ghost image

Check the pressure roller bushes they tend to wearout unevenly and cause lack of pressure between the press roller and hot roller.

+1