2060 cleaning web

[mikadonovan]

Hi, All. This may be a stupid question, but is there any way to run the machine (B140) with the cleaning web assembly removed or disabled?

[TonerMunkeh]

Not that I know of. There are too many sensor and motor signals that come from the web unit for it to be missing.

[Zaxxon]

Re: 2060 cleaning web

You can wind it a couple of feed backwards if you haven't a new in the carstock, works fine until you get the new.

[slimslob]

Re: 2060 cleaning web

If you really had to, you could remove the web roll from the web unit and wire the end sensor arm back. You will quickly destroy the hot roller as the web applies a thin layer of silicon oil to the hot roller in addition to cleaning it. Zaxxon suggestion of winding the roll back some is a better idea. As both the supply and take up shafts are the same, you could try swapping the two shafts around and use the other side of the web.

[BLADE]

Re: 2060 cleaning web

i,m pretty sure you just remove the web unit, take out the web out sensor and reconnect it to loose plug. machine will run fine

[teebee1234]

Re: 2060 cleaning web

You can remove the web with no modification or sensor adj. I did it on an emergency basis for 2 days until I got a new replacement (the gears were stripped).

[hossam]

Re: 2060 cleaning web

If you really had to, you could remove the web roll from the web unit and wire the end sensor arm back. You will quickly destroy the hot roller as the web applies a thin layer of silicon oil to the hot roller in addition to cleaning it. Zaxxon suggestion of winding the roll back some is a better idea. As both the supply and take up shafts are the same, you could try swapping the two shafts around and use the other side of the web.

I agree with that

[mikadonovan]

Re: 2060 cleaning web

You can remove the web with no modification or sensor adj. I did it on an emergency basis for 2 days until I got a new replacement (the gears were stripped).

That's good to know. I've had a couple bad motors as of late, and if you leave it in, it flat spots the orange roller.

[fshead]

Re: 2060 cleaning web

on a pinch i will swap the corona wire cleaning motor out and splice it into the web motor connectors,,it is a shorter wire harness.its the same motor..

[Exok]

Re: 2060 cleaning web

on a pinch i will swap the corona wire cleaning motor out and splice it into the web motor connectors,,it is a shorter wire harness.its the same motor..

That's a nice work around.