If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have a MP2553 that at start up out of the box I got a 672-11 code. Removed the controller and checked all connections, went to power up and machine was dead. Checked all fuses and voltage to PSU, not a single light or noise. Any ideas, Thanks.
I have a MP2553 that at start up out of the box I got a 672-11 code. Removed the controller and checked all connections, went to power up and machine was dead. Checked all fuses and voltage to PSU, not a single light or noise. Any ideas, Thanks.
Does this small box have a circuit breaker?? Check it if it does otherwise, Call your Ricoh TSM for an RA, if it's straight out of the box !!!!
I have a MP2553 that at start up out of the box I got a 672-11 code. Removed the controller and checked all connections, went to power up and machine was dead. Checked all fuses and voltage to PSU, not a single light or noise. Any ideas, Thanks.
Sounds DOA to me, an out of box failure. Send it back with a big poo in the box.
both boards, there is a tb out for this and cheap chips on the board are at fault. new boards will sort the problem as debs said. had this fault last week.
Comment