If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have an SC 552 on this machine that comes back every 1 or 2 days. I have rebuilt a fuser with all new thermistors. Only thing I haven't done is replaced the IH inverter. Any ideas would be much appreciated. Thanks.
I had an issue with faulty door switches causing random fusing codes. They replaced the fuser and then the IH coil so I go out to look and was messing with doors and it cleared. Replaced the switches and it never came back.
I have an SC 552 on this machine that comes back every 1 or 2 days. I have rebuilt a fuser with all new thermistors. Only thing I haven't done is replaced the IH inverter. Any ideas would be much appreciated. Thanks.
HR warm up error - Replace IH inverter if coil checks bad
I had an issue with faulty door switches causing random fusing codes. They replaced the fuser and then the IH coil so I go out to look and was messing with doors and it cleared. Replaced the switches and it never came back.
I know the bridge unit has a touchy switch. Perhaps that could be causing it?
I have an SC 552 on this machine that comes back every 1 or 2 days. I have rebuilt a fuser with all new thermistors. Only thing I haven't done is replaced the IH inverter. Any ideas would be much appreciated. Thanks.
I would also check if the ferrite-core rotation sensor has not been knocked out of position.
Comment