MPC 1500 SP - Sc573

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • nobody-here
    Trusted Tech

    Site Contributor
    100+ Posts
    • Mar 2008
    • 237

    #1

    MPC 1500 SP - Sc573

    Hi Guys,

    we had this machine with this error code. It's about Humidity and Temperature sensor. We replaced sensor, machine worked for a day but after the machine stopped again, same error.

    We brought into our lab and the machine was on line again (without any sensor replacement). Tested for a day was ok. But in the second day it's hanged again..

    We have very high temperature here in sicily now, and air conditioners work a lot... do you know something about "temperature warnings" or improving sensors "stability".

    thanks

    Vincenzo
    29 rouge unpair manque.... cous cous....
  • iMind
    Vacuum Cleaning Expert

    1,000+ Posts
    • Mar 2008
    • 1116

    #2
    Originally posted by nobody-here
    Hi Guys,

    we had this machine with this error code. It's about Humidity and Temperature sensor. We replaced sensor, machine worked for a day but after the machine stopped again, same error.

    We brought into our lab and the machine was on line again (without any sensor replacement). Tested for a day was ok. But in the second day it's hanged again..

    We have very high temperature here in sicily now, and air conditioners work a lot... do you know something about "temperature warnings" or improving sensors "stability".

    thanks

    Vincenzo
    OK you may have transport belt thermistor bad, check it first, then you can fiddle around with SP 1 017 1 to 6, but backup old values to SD card or print SMC please e carefull,
    sigpicWe can all Win, but at the end we all loose. Save the greyhound

    Comment

    • nobody-here
      Trusted Tech

      Site Contributor
      100+ Posts
      • Mar 2008
      • 237

      #3
      I will try your advices... I will save data because i can't print.
      Do you know where I should check SMC information about this problem?
      Thanks.
      V.
      29 rouge unpair manque.... cous cous....

      Comment

      • iMind
        Vacuum Cleaning Expert

        1,000+ Posts
        • Mar 2008
        • 1116

        #4
        Originally posted by nobody-here
        I will try your advices... I will save data because i can't print.
        Do you know where I should check SMC information about this problem?
        Thanks.
        V.
        Listen, the SMC holds only SCs codes (last ten) and all jam locations and all the machines factory setting for a good hardware, software relationship, ID, TD, registration, erase, firmware versions and so on, endless, this is just to give you a idea. The SMC does not tell you what the problem is, but you can check all your machines SP settings, if they are standard factory or if they have been changed. the SMC is your machines ID card.
        sigpicWe can all Win, but at the end we all loose. Save the greyhound

        Comment

        Working...