[Error Code] SC 680-004 Savin 5210SP

[bdesire]

After attempting to upgrade firmware I got this code and now I'm down. I've tried a new controller and eeprom with no luck. Any help would be greatly appreciated.

[Tonerbomb]

Re: SC 680-004 Savin 5210SP

what happened when you attempted the frimwar update????


680
-001
D BICU serial communication error: Time out
-002 D BICU serial communication error: Retry error
-003 D BICU serial communication error: Download error
-004 D BICU serial communication error: UART error
The serial communication error occurs in the BICU.
�� Noise
�� Defective BICU
Replace the BICU

you've toasted the BICU!!!!!!!!!!!!

[bdesire]

Re: SC 680-004 Savin 5210SP

what happened when you attempted the frimwar update????


680
-001
D BICU serial communication error: Time out
-002 D BICU serial communication error: Retry error
-003 D BICU serial communication error: Download error
-004 D BICU serial communication error: UART error
The serial communication error occurs in the BICU.
�� Noise
�� Defective BICU
Replace the BICU

you've toasted the BICU!!!!!!!!!!!!

Does this mean EEPROMs as well? and exactly how did the board get fried?

[Tonerbomb]

Re: SC 680-004 Savin 5210SP

Does this mean EEPROMs as well? and exactly how did the board get fried?

EEproms maybe.... What happened when you did the upgrade??? did you lose power?? use the wrong frimwar?? did you get any of the error codes for frimwar failure??? (E32, E34 ect)

[bdesire]

Re: SC 680-004 Savin 5210SP

EEproms maybe.... What happened when you did the upgrade??? did you lose power?? use the wrong frimwar?? did you get any of the error codes for frimwar failure??? (E32, E34 ect)

No error code for firmware failure, after reboot the machine just sits in boot up mode until it finally errors out. There is no control panel so I cant get into SP mode. Only one fan comes on.

[Tonerbomb]

Re: SC 680-004 Savin 5210SP

No error code for firmware failure, after reboot the machine just sits in boot up mode until it finally errors out. There is no control panel so I cant get into SP mode. Only one fan comes on.

That being the case, My guess is the wrong frimware was installed..............just my guess............


PS: Try to boot it with the hard drive disconnected and see if it comes up !!!!!!!!!!

[slimslob]

Re: SC 680-004 Savin 5210SP

No error code for firmware failure, after reboot the machine just sits in boot up mode until it finally errors out. There is no control panel so I cant get into SP mode. Only one fan comes on.

The service manual fr this model does not say how to access SP mode. For most Ricoh printers you can enter SP mode by turning on the power while holding down the "Escape" key and the "Online" key together for at least five seconds.