MPC 6501 - Finisher not detected after firmware update

Re: MPC 6501 - Finisher not detected after firmware update

I think ss12 has right. It needs a new finisher PCB.
There was something about the firmware is not fit for the board that was made in another factory after tsunamien.

[slimslob]

Re: MPC 6501 - Finisher not detected after firmware update

On some finisher models, the firmware is stored on an EEPROM. If this is the case, you can replace just that. If you have another finisher available, try swapping the PCBs.

[turbojetboy]

Re: MPC 6501 - Finisher not detected after firmware update

As per above reply, we have seen this a few times, wrong finisher version loaded.

[ss12]

Re: MPC 6501 - Finisher not detected after firmware update

You may have mistakenly loaded the the wrong finisher firmware.I've done this before and ended up having to replace the finisher pcb

Hi

I updated the Engine, system/copy and finisher firmware on an MPC 6501. Now the machine does not detect the finisher at all.

Any suggestions?