Is there a common cause for SC-304, SC-350, and SC-352 error codes? I have swapped out all possible PCB's & replaced the ID sensor. I have noticed that the settings in SP-3103 are not where they should be based on other like copiers. Why would this be, and what could be causing these problems? Thank you for your help.
-
-
Re: Ricoh Aficio 1035
Did you execute SP 3001-02 after replacing the ID sensor? A bad drum could cause all three, so can after market developer and toner. Rebuild the PCU and replace the developer using Genuine Ricoh parts and supplies. Replace the HV power supply. After all else fails. Replace the dinosaur.
Comment