SL-C2670FW A3-3112 code after replacing MFP board

[mthomasebs]

We had a SL-C2670FW which was subject to a lightning strike, machine capability seemed ok, but network information was blank and couldnt be pinged.

We replaced the MFP board and now we get an error code A3-3312

Actuator Sensor Failure #A3-3312: Call for service if the problem persists.
► Symptom
The outer temperature sensor is defective.

I've entered service mode and tried to check the sensors output but as i have a red light on the display i'm guessing i cant run the engine test routines.

Could this be that the strike has taken out other components? Even though the code wasnt present before MFP board replacement?

Any help would be appreciated!

[mthomasebs]

Re: SL-C2670FW A3-3112 code after replacing MFP board

Solved. Re-checked the ribbon cables and noticed damage.