FIN501L Inner Finisher problem for MX3 - MX4 series

[hellcat]

Having a problem on a SLX4300LX with the inner finisher. It is not properly aligning the pages together when stapling. Also does it during normal sorting just not as bad. I have tried all the finisher adjustments in simulation. The finisher is about 1 year old with 60K total on the machine output. The firmware is up to date.

Examples

https://www.dropbox.com/s/9og7y557810jb0v/20170816_145555.jpg?dl=0

https://www.dropbox.com/s/im72yz6gz147vjz/20170816_145559.jpg?dl=0

[arnh79]

Re: FIN501L Inner Finisher problem for MX3 - MX4 series

On that series of finisher the belt driven ejection section (sorry, not sure of technical term but it's the two belts the turn and kick out the paper on to the tray) easily get knocked out of alignment. So if one "foot" is in a different position than the other the paper will not sit evenly. Fortunately it's also easy to line them back up. Hold one foot/belt tightly and grab the other one and pull until they are lined up.

[hellcat]

Re: FIN501L Inner Finisher problem for MX3 - MX4 series

I will double check this when I go back out today, Thank You