[Misc] MX FNX2 Saddle Finisher -- Folding only ?

[Guest]

Hello,

I have a techincal question concerning the MX FNX2 Saddle Finisher.

I have some printed papers that i would want to fold, and i wondered if by any means i can use the Saddle Finisher to fold-it... I do not need to print over again. Just to fold and put two stapples.

Would it be possible ?

Malk

[drowranger]

Re: MX FNX2 Saddle Finisher -- Folding only ?

if the optics are clean, guessing you need to fold a3

load the printed paper to a tray and load number of paper you want to fold x2 to document feeder. select saddle copy , 2 side to 2 side and it will do the trick. for this to work optics has to be clean. Do a test before using the pre printed paper.

Other way is to print a dot or something very small using the pc on the last page of the number of paper you want to fold x4 . select pamplet , 2 staples in middle. and it should do the trick. test it .

Good luck.

[Malksharan]

Re: MX FNX2 Saddle Finisher -- Folding only ?

if the optics are clean, guessing you need to fold a3

load the printed paper to a tray and load number of paper you want to fold x2 to document feeder. select saddle copy , 2 side to 2 side and it will do the trick. for this to work optics has to be clean. Do a test before using the pre printed paper.

Other way is to print a dot or something very small using the pc on the last page of the number of paper you want to fold x4 . select pamplet , 2 staples in middle. and it should do the trick. test it .

Good luck.

T

Thanks, this trick worked, however it is sad that we cannot use only the folding/stappling function i.e. use the MX FNX2 as a feeder to fold/staple paper.

Many thanks,

Malk