sharp mx-2610n

[Innocent]

Can anyone please help me with my sharp mx-2610n, when I switch on it does not start but only flash orange and green with no display, when I open the left side cover I see green light flashing on the formatter board, on the network port the lights flashes at the same time, if I'm not wrong the lights on the network port must not flash together, one must be on and the other one must be flashing

[ZOOTECH]

Re: sharp mx-2610n

Can anyone please help me with my sharp mx-2610n, when I switch on it does not start but only flash orange and green with no display, when I open the left side cover I see green light flashing on the formatter board, on the network port the lights flashes at the same time, if I'm not wrong the lights on the network port must not flash together, one must be on and the other one must be flashing

Will it boot up if network cable unplugged? The green lights on the MFP pwb will point to the problem.

[yob]

Re: sharp mx-2610n

I would try popping in a known good sd card. we've had several sd cards go bad giving goofy problems.

[Innocent]

[vlad_robas]

Re: sharp mx-2610n

check sd card contact's

[Innocent]

Re: sharp mx-2610n

I did but I still get the same results

[Sharptech56]

Re: sharp mx-2610n

Sounds like you need to replace memory or the MFP board

[Leebs14]

Re: sharp mx-2610n

New SD card required. I've had a few SD card failures on 2310 and 2314, so I'd go with replacing the card.


Sent from my iPhone using Tapatalk