If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Just wondering if anyone has had trouble with webs not advancing on mx-6240-7500 fusing units, wires to Web motor must be fragile, I've had a few. I just solder in new wire to repair, doing harness would be a bear.
Last edited by Sharptech0892; 08-11-2016, 07:53 PM.
Reason: Spelling
