[Error Code] mx 2610

[foudl]

Error code f3-12 tray 1 prob. the motor is turning but display shows ''tray 1 ready to open'' even if there is paper in.

Anyone seen this before ??

[nottoosharp]

Re: mx 2610

Error code f3-12 tray 1 prob. the motor is turning but display shows ''tray 1 ready to open'' even if there is paper in.

Anyone seen this before ??

Is the shaft bent? Sometimes it will have a slight bend and that prevents the gear from popping out and engaging properly.


Sent from my iPhone using Tapatalk

[mttech]

Re: mx 2610

Test the sensors in the cassette. If either the paper empty sensor or the upper limit sensor is bad the lift motor will overdrive and code out.

[nottoosharp]

Re: mx 2610

Test the sensors in the cassette. If either the paper empty sensor or the upper limit sensor is bad the lift motor will overdrive and code out.

Agreed. Also check to see if the sensor flag is worn down.


Sent from my iPhone using Tapatalk

[foudl]

Re: mx 2610

How do you reach those flag there is a plastic protector that covers them (clud1), by the way in sim 30 the sensor clud1 is hilighted even if if i take the cassette out.

Thanks for the inputs.

[nottoosharp]

Re: mx 2610

How do you reach those flag there is a plastic protector that covers them (clud1), by the way in sim 30 the sensor clud1 is hilighted even if if i take the cassette out.

Thanks for the inputs.

Take the steel plate off the back of the paper feed cassette


Sent from my iPhone using Tapatalk

[mttech]

Re: mx 2610

That sounds like a probable bad sensor. They are not expensive and are known to fail. Replace them all while you have feed station out and save another headache from happening down the road.

[spanky]

Re: mx 2610

If the paper does not lift the upper limit sensor is bad.

If paper lifts the paper empty sensor is bad.

Replace both as stated to prevent another problem later.