Copier gives me the attached sheet. And an F2 error call for service but no specifics. Normally it would have something after F2. Ive checked toners, developers, fuser and drums. Sometimes it flashes an issue with ppd1-n2 which may not be exact because it doesn't really show that for very long. I checked the sensor and it doesn't show anything wrong. Could this be correlated to the resist sensor being attached with a wad of paper aka bad resist sensor? Fixed the resist sensor and that error code went away so I don't think they're related but *shrugs*
-
-
Re: Sharp MX-2600N F2 error
Some F2 codes point to quite a few toner related issues. If you look up sim 22-4 it doesn't have the complete code shown? But based on that image you uploaded, try this first, pull out the TC1 belt assembly and look at the drive gear on the right rear side. Those gears have been known to sheer. If it hasn't completely done that it may also try to feed the paper through but jam before it feeds the fuser. I can't remember if I had any do that and have a code associated with it in the "F2" series.
I also noticed some L4 codes on that partial sim 22-6 printout. You may also want to check the drum units to see if any cleaning blades have flipped. -
Re: Sharp MX-2600N F2 error
You can also go into 25-1 and monitor your toner concentrations. That will show you if it's a particular color, in order to narrow it down.Comment
Comment