MX-M283n e7-90 codes followed by not booting up

[techwurk]

Hello all,
Customers mx-m 283 has thrown E7-90 codes twice in the past couple weeks, each time the code went away after cycling the power.
but today I get a call and the unit is stuck at the first please wait and language display screen, it is not booting past that point.
Tomorrow I will get there for the service call and will try first reseating connectors and MFP. I have read about some possible causes such as boot roms, PCU and or MFP boards and even the HDD. Has anyone faced a similar issue? If so, any help is appreciated

[JLSam]

Re: MX-M283n e7-90 codes followed by not booting up

First thing I would do is try is re-seating the PCU PWB. Reboot and see what happens. If problem continues, then I would do an emergency firmware update using the CN update function.

In the service manual page 7-3, [7] Firmware Update > 2. Update Procedure > D. Firmware update using the CN update function.

I use the DipSwitch method.
Good luck.