The calibration plate shutter in resist sensor doesn't open fully. Tested in Sim 6-1 PCSS, wound up doing a play and left the shutter wide open with a piece of paper after troubleshooting. Also, shutter is not warped either, like the B/C-402 units.
I'm quoting them a resist sensor unit (DUNT-1099USZZ), it contains the solenoid too. Anyone ever replace this part on this model? Do you know how long it will take? (I've never replaced it actually.) Service Manual doesn't say jack squat in the few 188 pages. Any advise would be awesome.
See picture for your "Trust me I'm an engineer" entertainment.
53df05b6-0516-4da8-b18d-fd3d540967bd.jpg
I'm quoting them a resist sensor unit (DUNT-1099USZZ), it contains the solenoid too. Anyone ever replace this part on this model? Do you know how long it will take? (I've never replaced it actually.) Service Manual doesn't say jack squat in the few 188 pages. Any advise would be awesome.
See picture for your "Trust me I'm an engineer" entertainment.
53df05b6-0516-4da8-b18d-fd3d540967bd.jpg