Good morning all this is a very unusual issue on a Mx-7580 and recently lost our support from sharp but my job is still to fix the machine
- I am getting the Black registration pattern on back of single sided prints - followed on next page by the CMY registration patterns
all drums are relatively new and clean - both belts are new - registration / calibrate sensors under belt were just cleaned and drum grounds all have fresh dielectric grease
did 44-2, 50-22, 44-27, 44-6, 44-26, 46-74 all with no issues after cleaning
Has anyone seen a similar issue or know which board would be generating this pattern?
Thank You all in advance for your assistance!!
- I am getting the Black registration pattern on back of single sided prints - followed on next page by the CMY registration patterns
all drums are relatively new and clean - both belts are new - registration / calibrate sensors under belt were just cleaned and drum grounds all have fresh dielectric grease
did 44-2, 50-22, 44-27, 44-6, 44-26, 46-74 all with no issues after cleaning
Has anyone seen a similar issue or know which board would be generating this pattern?
Thank You all in advance for your assistance!!