I need to increase the rate of (upper) fuser web advancement in a Sharp MX-M753.
Sim 43-32 has three sub items -
----------------------------
'A' - Job end comp act check
'B' - Job end comp act interval
'C' - Job end comp act cnt
----------------------------
The verbiage in the manual perplexes me.
Item 'B' reads "Interval of the print quantity of compulsory action of the fusing web motor at job end".
'B' has a value range of 1 - 255.
Is this the adjustment that I need?
Should the value be increased or decreased to cause additional web feed?
TIA!
...Lorenzo
Sim 43-32 has three sub items -
----------------------------
'A' - Job end comp act check
'B' - Job end comp act interval
'C' - Job end comp act cnt
----------------------------
The verbiage in the manual perplexes me.
Item 'B' reads "Interval of the print quantity of compulsory action of the fusing web motor at job end".
'B' has a value range of 1 - 255.
Is this the adjustment that I need?
Should the value be increased or decreased to cause additional web feed?
TIA!
...Lorenzo
Comment