[Misc] Adjustment for Sharp 4070 Saddle stitch fold position.

[CopyTech1975]

The saddle stitch fold position is not perfectly centered while doing letter R pamphlet folds. The booklet is about a 16th of a inch off, is this within tolerances for this machine or is there an adjustment to correct the position of the fold? Couldn't find the procedure in the manual. Any thoughts or info?
Thanks

[leo34staffs]

Re: Adjustment for Sharp 4070 Saddle stitch fold position.

The saddle stitch fold position is not perfectly centered while doing letter R pamphlet folds. The booklet is about a 16th of a inch off, is this within tolerances for this machine or is there an adjustment to correct the position of the fold? Couldn't find the procedure in the manual. Any thoughts or info?
Thanks

IF the firmware is not too old, the Staple & Fold
positions for Saddle Stitch can be independently adjusted
using SIM3-10 (CJ = Saddle Stitch, CK = Saddle Fold).

[copiertec]

Re: Adjustment for Sharp 4070 Saddle stitch fold position.

Did you look at simulation 3-10? Have you made sure you are at factory default for these settings? If all settings are at factory defaults adjust from there and see how it goes.