If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
If you've ever worked on the Ricoh MP series I swear these BP's are just Ricoh's with Sharp Covers. The ADF rollers are now a pain to replace vs the MX-5071's, The fuser is a hassle compare to the previous gen. Our manager just agreed with Tom and was like F it just order the whole unit. Because some of our clients are over 60 mins away they don't want us spending most of our day at just 1 call. But on the plus side we did have a lot of issues with the previous gen. of fusers with H codes, fusers barely making it to 60k prints. We rolled out the BP's and we haven't really have any calls.
We also had a lot of issues with the 5071 fusers failing early. The BP's have been working better, but we still had 2 fusers fail at less than 10k prints already.
Bulletin released today states that the BP-FB700 has been replaced by the BP-FB702.
Great! We were able to order the BP-FB702. With this fuser, I do believe that it is best to order the fuser, instead of rebuilding, but we have 2 BP-LH700's that came in a couple of months ago.
Thank you
Comment