scanner key ar-450n

[swagreis]

Iam trying to do this soultion
I tried to change flah memory in Main board but it is not the right solution
I think it is in IMC board in EPROM(32 pin) Ic (not boot or main flash memories)
or both changing flash memory in main board and EPROM in IMC board
try and tell me what is result.

[DINGO]

re

ingHi

By now i d'ont do anything, because i'm not sure.

I go wait, when take the copier for my office.

thanks

[lky1978]

dingo, go to sim 22-10, check the option ar-ns2 exist or not? then nic card (ar-nc5j)exist?if ar-nc5j does not exist, try to take out and fix again, dust can make it bad contact..

[lky1978]

dont try to swap mfp board from another machine, it can make the ar-ns2 disable, coz sharp engineer work very smart, the engine serial no. eeprom in mfp board consist with eeprom in main board, if u change, once u on , the copier will detect different serial no. then will boot twice, product key erased....

[DINGO]

re

Thanks Iky1978

Everything is ok, definitly the copier least the "product key of expansion kit"

thanks