MX4100 tray switching with In-Design on a MAC

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • hammer
    Trusted Tech

    100+ Posts
    • May 2008
    • 111
    #1

    [Misc] MX4100 tray switching with In-Design on a MAC

    Hi All, I am having a problem with a new MX4100 that we have just installed. The configuration is standard two paper trays, with a saddle stitch finisher. The client, using a MAC, wants to print a job with 20 pages, in a booklet fashion and wants page one to come from tray 2, with all other pages from tray 1. The problem is, the copier will not switch trays and prints all pages from tray 2. (Tray switching is on and both trays are set for A4R). The MAC is 10.6.4 and the latest driver is on the MX. Any ideas?
    Tags: copier, dealing, finisher, hi all, job, mac, mx4100, paper, print, standard, switch
    • OMD-227
      #2

        Comment

        • hammer
          Trusted Tech

          100+ Posts
          • May 2008
          • 111
          #3
          Thanks Wazza. I saw that on the Sharp Tech site and it kinda helped. I also had to turn on 2-up printing within the driver to enable tray switching!! Strange one, but working now. I always find, when dealing with design software, that you are never sure if the application controls pamphlet making or the driver does.
          Thanks for you help.

            Comment

            Previous template Next
            Working...