[Misc] Notepad lines on second side of the copy

[fanasa]

we have a MX7000, it is makings lines only on the second side of the copies when you make 2-2 from the feeder. But the lines look like if we were copying a notepad. all teh boards in the feeder have been changed, the scanner boards, the CCD, the MFP, the PCU, the RAM, and the whole feeder unit and it is still doing that.

I have not been there, but a supervisor has. I am going to troubleshoot it tomorrow to see what I can find out, but I wanted to see if any of you have seen this before. I will be updating the firmware tomorrow as well.

Please let me know.
I have attached the page with lines for you to see what it's doing

[OMD-227]

Did you end up getting this fixed?
I cant believe I didnt see this post before....... I know what this is...... Its caused by a faulty DSPF memory board. Thats the small memory board that mounts ontop of the scanner board. The DSPF CCD unit harness plugs into it.
I have had this exact fault many times, and its always been the DSPF memory board.

I was looking for another post, when I saw this.
Hope you sorted it out by now.