ar-m450n memory

[DINGO]

Hi,good night.

I have a question, that i like take your opinion.

I have some ar-m450n, and i do not understand because same
as more capacity in read originais, before display "memory full, for ex. in job build, then others???

Of corse i`m talking in copiers with same memory, alls without hdd, only with 256mb opcional, , and same
firmw. version, and same opcionals.

I have this issue, because i have them in a same copy center, and there are great diference, some read more
50% them others.

any idea i`m glad

regards

[igi]

Re: ar-m450n memory

hi
the toner coverage of the original will make a difference.
and see if this model got memmory alocation,via key op codes
more for copy and less for printing.
i am personally a believer in more memmory the better
good luck

[DINGO]

Re: ar-m450n memory

hi
as i said, i was tested with the same original, and of corse with the same % black coverage.

about the memory, i c`ant found anything in the key operators.

regards

[igi]

Re: ar-m450n memory

HI again
is the DPI set same
good luck

[DINGO]

Re: ar-m450n memory

hi igi
i do not understand?
in copy mode i think that hav`nt dpi adjust, may be i`m wrong.

[igi]

Re: ar-m450n memory

hi igi
i do not understand?
in copy mode i think that hav`nt dpi adjust, may be i`m wrong.

Hi
i checked the manual there is 2 settings for scanning originals,diferent DPI settings
hope thath helps
good luck

[DINGO]

Re: ar-m450n memory

thanks, but sorry, i c`ant found aything about that in my manual.
thanks anywai.

[igi]

Re: ar-m450n memory

600dpi x 600dpi scanning mode
Use this program to change the original scanning
resolution of the automatic document feeder from
600 x 300 dpi to 600 x 600 dpi.
If this mode is set, the copy quality for fine
characters and fine lines will be improved but the
original scanning speed will be slower.
NOTE
If the original scanning speed is more important than higher
resolution, do not set this program.
Quick scan from document glass
Use this program to change the original scanning
resolution on the document glass from 600 x 600dpi
to 600 x 300 dpi.
If you set this program, the first copy time will be
shorter but the copy image will become a little more
coarse.
NOTE
If

hi from operation manual
p-33
good luck