Sharp MX 2700N Auto Calibration

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • schotschen
    Technician
    • Nov 2011
    • 33
    #1

    Sharp MX 2700N Auto Calibration

    Hey Guys,
    we have Sharp MX 2700N here.
    After a few Copys the Maschine runs Auto Calibration.
    This take a Minute an it goes on to Copy or Print...
    So the performance is dead slowly.
    Maintenance is all Done 20K ago.
    Any Ideas out There?
    Cheers
    Daniel
    Tags: None
    • Ditchman
      Technician

      Site Contributor
      50+ Posts
      • Feb 2011
      • 51
      #2
      Re: Sharp MX 2700N Auto Calibration

      Daniel

      Have you done the full calibration with the jig lately?

      If not this will definitely help

      Paul

        Comment

        • schotschen
          Technician
          • Nov 2011
          • 33
          #3
          Re: Sharp MX 2700N Auto Calibration

          Thanks Paul! Works fine!

            Comment

            • lky1978
              Trusted Tech

              250+ Posts
              • Mar 2009
              • 475
              #4
              Re: Sharp MX 2700N Auto Calibration

              daniel,

              make sure that the machine was updated with latest firmware.Latest firmware improve a lot print quality and reduce duration for calibration.

                Comment

                Previous template Next
                Working...