I probably have a dumb question, but here goes anyway. I have an MXM450 that when copying through the doc feeder reduces the image by about 2%, but off the glass it's fine. I'm sure there is a simple adjustment but I sure can't find it. And yes I do have the manual. Please help the feeble minded.
-
I know I should be ashamed of myself. Strangely though, I am not. -
Re: Mxm450 reducing through df
It is addjusted thru sim 48-1 -
Re: Mxm450 reducing through df
So far that isn't changing anything.I know I should be ashamed of myself. Strangely though, I am not.Comment
-
Re: Mxm450 reducing through df
You may want to try sim 50-6. This would be used if the reduction is in the sub scan direction.Comment
-
Re: Mxm450 reducing through df
try 48-01 values 5 or 6
also you can try
48-05 values 4 or 5
cheers
Comment
-
Re: Mxm450 reducing through df
Thank you gentlemen for the replies. Sim 50-6 value 3 finally did the trick. I could have sworn I tried that before, but apparently not. Thanks again.I know I should be ashamed of myself. Strangely though, I am not.Comment
Comment