MXM850N L4-06 error

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • blazebusiness
    replied
    Re: MXM850N L4-06 error

    Originally posted by redserv
    sorry guys for the improper information its L4-04,thanks for the help guys.
    Glad to help out....please post back & let us know what fixed the problem. Good Luck.

    Leave a comment:


  • redserv
    replied
    Re: MXM850N L4-06 error

    sorry guys for the improper information its L4-04,thanks for the help guys.

    Leave a comment:


  • blazebusiness
    replied
    Re: MXM850N L4-06 error

    Originally posted by redserv
    yes guys has been one of those weeks, been having lots off MFP problems,the error says developer motor Problem, i have done a visual inspection on the developer drive gear, the developer unit seems ok,however when i try to rin simulation 25-1 nothing happens, the motor wont turn, i dont have a motor to change at the moment,have you guys experienced L4-06 error code with this MFP?thanks again guys, i cant live without this site
    Please verify that code for us. Agree that you probably mean L4-04 as this model has no L4-06 code. Have had dv units that seemed ok but replacing the unit fixed the problem anyway. Check the voltage to that motor as per rainmaker. Also check that drum turns freely and blade has not flipped. Longshot-----updating firmware can also occasionally solve problems.

    Leave a comment:


  • redserv
    replied
    Re: MXM850N L4-06 error

    thanks for the tip i'll check it out and report back.

    Leave a comment:


  • rainmaker
    replied
    Re: MXM850N L4-06 error

    I am think the code is a L4-04. before i throw in a motor,i would check to see if you have 38 volts(dc) to the motor.when you go into test command 25-1 does it go right into the L4? good luck..rainmaker

    Leave a comment:


  • redserv
    started a topic MXM850N L4-06 error

    MXM850N L4-06 error

    yes guys has been one of those weeks, been having lots off MFP problems,the error says developer motor Problem, i have done a visual inspection on the developer drive gear, the developer unit seems ok,however when i try to rin simulation 25-1 nothing happens, the motor wont turn, i dont have a motor to change at the moment,have you guys experienced L4-06 error code with this MFP?thanks again guys, i cant live without this site
Working...