MX-2610 admin password reset

[Garp]

Re: MX-2610 admin password reset

Thanks lads, this thread helped me out.
Have a nice day!

[thomfish]

Re: MX-2610 admin password reset

This is a picture of the dip switches on the MFP board. Do not be fooled by the picture, these are VERY, VERY TINY. I believe this is from a 5111. The 2610 dip switches are also on the MFP board but are more towards the back of the board. Flip the dip, boot up the machine. It will go into something like "data and counter clear", select that, you will see the usual 24-30, execute. Then power down, flip dip back to original position and power up. Admin password should work.
[ATTACH=CONFIG]26208[/ATTACH]

I have to reset admin password on MX-5112N.
After using dip switch machine went into sim24 mode. I executed 30 and 31 to reset passwords. Now machine does not accept 'admin' password to change for example mfp display pattern (this password works fine before). Could you help please?
I need also access to the settings (for example network settings) so need login as administrator but this password does not reset to default so how can I reset it?
admin and sysadmin do not work (is it any other password?)

Another question: Is it possible to set ip address or change to DHCP from sim mode (67-17 does not reset nic) ? How to change this setting without password (which does not work)

[oeshuron]

Re: MX-2610 admin password reset

Have a MX-5111n in shop. Can not get password to reset. Tried rolling back firmware as well as Service Mode. Can get Sim 24 by setting right hand dip but password still not accepted after power off and on. Any ideas?

[MdangerP]

Re: MX-2610 admin password reset

I'm pretty sure its just dip switch 1 on the control board (board with the nic and fax ports), It automatically takes you to 24-30--- execute. Turn machine off flip switch back. I just did this on a 3115 without data security. With data security... No clue if its the same.

[oeshuron]

Re: MX-2610 admin password reset

I'm pretty sure its just dip switch 1 on the control board (board with the nic and fax ports), It automatically takes you to 24-30--- execute. Turn machine off flip switch back. I just did this on a 3115 without data security. With data security... No clue if its the same.

Dip switch on right labeled 1. Pushed down to ON and booted to Sim 24. Did both 30 & 31 resets. Powered off, flipped back, and powered on. Still won't authenticate. No security kit.

[oeshuron]

Re: MX-2610 admin password reset

Have also done HDD reset, Memory Clears, Revert F/W to previous (But not back to 4.00 as don't have access to). Machine will also no longer print 22-6. Could update to firmware 8.xx from 4.xx cause this?

[oeshuron]

Re: MX-2610 admin password reset

I believe the problem may stem from SD Card. Anyone have an image of the SD card for the MX-5111n by chance?

[oeshuron]

Re: MX-2610 admin password reset

Co-worker discovered sim 62-14 and when ran seemed to clear whatever was holding the change up.

[Matoku]

Re: MX-2610 admin password reset

I have tried this on my 4141. initially not works. after work around and I found that to totally remove the old password I run the SIM62-14. no it back to user name is admin and password to admin.
The dip switch is on the left hand side for us direct to SIM 24-30/31. but it not reset the password. after run 62-14 then the password reseted.

thanks